FRONT BUMPER > INSTALLATION |
| 1. INSTALL FRONT BUMPER END RETAINER LH |
Install the front bumper end retainer LH with the 3 nuts.
| 2. INSTALL FRONT BUMPER END RETAINER RH |
| 3. INSTALL FRONT BUMPER SIDE SUPPORT LH |
Attach the clip to install the front bumper side support LH.
Install the clip.
Install the screw.
| 4. INSTALL FRONT BUMPER SIDE SUPPORT RH |
| 5. INSTALL FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY LH |
Install the front bumper No. 2 extension sub-assembly LH with the 4 nuts.
| 6. INSTALL FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY RH |
| 7. INSTALL FRONT BUMPER REINFORCEMENT |
Install the front bumper reinforcement with the 6 nuts.
| 8. INSTALL FRONT BUMPER ARM LH |
Install the front bumper arm LH with the 3 nuts.
Attach the clamp.
| 9. INSTALL FRONT BUMPER ARM RH |
| 10. INSTALL FRONT FENDER MAIN SEAL LH |
Install the front fender main seal LH.
| 11. INSTALL FRONT FENDER MAIN SEAL RH |
| 12. INSTALL FRONT BUMPER COVER |
w/ Fog Light:
Connect the fog light connectors.
w/ Intuitive Parking Assist System:
Connect the ultrasonic sensor connectors.
Attach the 4 clamps to connect the wire harness.
Install the front bumper cover with the 4 bolts.
![]() |
Install the 4 screws labeled A and 3 screws labeled B.
| *1 | Screw A |
| *2 | Screw B |
| *3 | Bolt |
Install the 4 bolts.
for Steel Type Bumper:
Install the 2 pin hold clips.
for Resin Type Bumper:
Install the 2 screws.
| 13. INSTALL FRONT BUMPER CENTER UPPER RETAINER |
Install the front bumper center upper retainer with the 6 nuts.
| 14. INSTALL FRONT END PANEL LH |
Attach the 3 claws to install the front end panel LH.
Install the 2 screws and 2 clips.
| 15. INSTALL FRONT END PANEL RH |
| 16. INSTALL RADIATOR GRILLE SUB-ASSEMBLY |