Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
(Click here)


2. REMOVE FRONT END PANEL LH


B354979E01
  1. Put protective tape around the front end panel LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 screws and 2 clips.

  1. Detach the 3 claws and remove the front end panel LH.



3. REMOVE FRONT END PANEL RH

HINT:
Use the same procedure described for the LH side.



4. REMOVE FRONT BUMPER COVER


    B354983E01
  1. for Steel Type Bumper:

    1. Using a screwdriver, remove the 2 pin hold clips.

      HINT:
      Use the same procedure for the RH and LH sides.



    B354982
  1. for Resin Type Bumper:

    1. Remove the 2 screws.

      HINT:
      Use the same procedure for the RH and LH sides.



    B354984E01
  1. Remove the 4 bolts.
    Text in Illustration 
    *1
    Screw A
    *2
    Screw B
    *3
    Bolt

  1. Remove the 4 screws labeled A and 3 screws labeled B.



    B354985E01
  1. Remove the 4 bolts.
    Text in Illustration 
    *A
    w/ Intuitive Parking Assist System

  1. w/ Fog Light:

    1. Disconnect the fog light connectors and remove the front bumper cover.

  1. w/ Intuitive Parking Assist System:

    1. Detach the 4 clamps and disconnect the wire harness.

    2. Disconnect the ultrasonic sensor connectors and remove the front bumper cover.



5. REMOVE FRONT FENDER MAIN SEAL LH


    B354986
  1. Remove the front fender main seal LH.



6. REMOVE FRONT FENDER MAIN SEAL RH

HINT:
Use the same procedure described for the LH side.



7. REMOVE FRONT BUMPER ARM LH


    B354989
  1. Detach the clamp and disconnect the engine room wire.

  1. Remove the 3 nuts and front bumper arm LH.



8. REMOVE FRONT BUMPER ARM RH

HINT:
Use the same procedure described for the LH side.



9. REMOVE FRONT BUMPER REINFORCEMENT


    B354990
  1. Remove the 6 nuts and front bumper reinforcement.



10. REMOVE FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY LH


B354991
  1. Remove the 4 nuts and front bumper No. 2 extension sub-assembly LH.



11. REMOVE FRONT BUMPER NO. 2 EXTENSION SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



12. REMOVE FRONT BUMPER SIDE SUPPORT LH


B354987E01
  1. Remove the screw.

  1. Using a screwdriver, turn the clip 90° and remove the clip.

  1. Detach the clip and remove the front bumper side support LH.



13. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure described for the LH side.



14. REMOVE FRONT BUMPER CENTER UPPER RETAINER


    B354981
  1. Remove the 6 nuts and front bumper center upper retainer.



15. REMOVE FRONT BUMPER END RETAINER LH


B354988
  1. Remove the 3 nuts and front bumper end retainer LH.



16. REMOVE FRONT BUMPER END RETAINER RH

HINT:
Use the same procedure described for the LH side.