Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)



2. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure described for the LH side.



3. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intuitive Parking Assist System)


    B354818
  1. Remove the No. 1 ultrasonic sensor as shown in the illustration.

    HINT:
    The illustration shows the No. 1 ultrasonic sensor for the LH. The horizontal orientation of the No. 1 ultrasonic sensor for the RH is opposite that of the image shown in the illustration.



4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intuitive Parking Assist System)


    B354817
  1. Remove the No. 1 ultrasonic sensor retainer as shown in the illustration.

    HINT:
    The illustration shows the No. 1 ultrasonic sensor retainer for the LH. The horizontal orientation of the No. 1 ultrasonic sensor retainer for the RH is opposite that of the image shown in the illustration.



5. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET


    B354993
  1. Remove the clip.

  1. Remove the 10 bolts and front bumper extension mounting bracket.



6. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light)


    B356293E01
  1. Detach the 2 claws and remove the front bumper hole cover LH.
    Text in Illustration 
    *A
    for Steel Type Bumper
    *B
    for Resin Type Bumper



7. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:
Use the same procedure described for the LH side.



8. REMOVE FRONT BUMPER HOLE COVER LH (w/ Fog Light)


    B354994
  1. for Steel Type Bumper:

    1. Detach the 2 claws and remove the front bumper hole cover LH.



    B354996
  1. for Resin Type Bumper:

    1. Remove the clip.

    2. Detach the 2 claws and remove the front bumper hole cover LH.



9. REMOVE FRONT BUMPER HOLE COVER RH (w/ Fog Light)

HINT:
Use the same procedure described for the LH side.



10. REMOVE FRONT LICENSE PLATE BRACKET SUB-ASSEMBLY


    B354992
  1. Remove the 2 screws and front license plate bracket sub-assembly.



11. REMOVE FRONT BUMPER EXTENSION LH


    B356289E01
  1. Remove the 4 nuts and front bumper extension LH.
    Text in Illustration 
    *A
    for Steel Type Bumper
    *B
    for Resin Type Bumper



12. REMOVE FRONT BUMPER EXTENSION RH

HINT:
Use the same procedure described for the LH side.



13. REMOVE LOWER NO. 1 RADIATOR GRILLE


    B355000
  1. Detach the 17 claws and remove the lower No. 1 radiator grille from the front valance panel.