Home › BODY › EXTERIOR › REAR BUMPER (for Steel Type Bumper)

REAR BUMPER (for Steel Type Bumper) > REMOVAL

for Preparation Click here


CAUTION:
As the rear bumper cover is extremely heavy, the engine lifter may suddenly drop if the instructions listed in the repair manual are not followed. Therefore, always follow the instructions listed in the repair manual when performing this procedure.



1. REMOVE WIRING HARNESS CONNECTOR (w/ Towing Package)


    B355009
  1. Disconnect the connector.

  1. Detach the 2 claws and remove the wiring harness connector.



2. REMOVE CONNECTOR COVER (w/o Towing Package)

HINT:
Use the same procedure described for the wiring harness connector.



3. REMOVE REAR BUMPER COVER


    B355010
  1. Disconnect the 2 connectors and detach the clamp.



  1. w/ Towing Package:



    1. Using an engine lifter or equivalent, remove the 12 bolts and rear bumper cover.


      B355012

      NOTICE:
      1. Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.
      2. Be sure to perform the operation with 2 persons or more.
      3. Be careful not to damage the rear bumper cover.



  1. w/o Towing Package:



    1. Using an engine lifter or equivalent, remove the 8 bolts and rear bumper cover.


      B355011

      NOTICE:
      1. Using plate lift attachments or equivalent, set the rear bumper cover on a flat surface.
      2. Be sure to perform the operation with 2 persons or more.
      3. Be careful not to damage the rear bumper cover.