Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING (for CrewMax)

FRONT DOOR BELT MOULDING (for CrewMax) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E02
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT UPPER ARMREST BASE PANEL LH


    B360301
  1. Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel LH.



    B360303
  1. Disconnect the master switch connector.



3. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B168274E02
  1. Detach the 3 clips and remove the front lower door frame bracket garnish.



4. REMOVE FRONT DOOR ARMREST COVER LH


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B354849E01
  1. Remove the 2 screws.

  1. Remove the clip.

  1. Detach the 9 clips and remove the trim board cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


B166364E02
  1. w/ Power Mirror Control System:
    Disconnect the connector labeled A.

  1. Remove the 3 nuts.

  1. Detach the claw and remove the outer rear view mirror assembly.



7. REMOVE FRONT OUTER DOOR GLASS WEATHERSTRIP ASSEMBLY LH


B165859E02
  1. Put protective tape around the weatherstrip outer.

  1. Using a moulding remover, detach the claw and remove the weatherstrip.