Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repairs" after replacing the heated oxygen sensor (Click here).



1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A240675E01
  1. Using SST, install the sensor.

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *a
    Fulcrum Length

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and wrench are connected in a straight line.
    3. Perform "Inspection After Repairs" after replacing the Perform "Inspection After Repairs" after replacing the heated oxygen sensor (Click here).

  1. Connect the connector and 2 clamps.



2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A240677E01
  1. Using SST, install the sensor.

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *a
    Fulcrum Length

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and wrench are connected in a straight line.
    3. Perform "Inspection After Repairs" after replacing the Perform "Inspection After Repairs" after replacing the heated oxygen sensor (Click here).

  1. Connect the connector.