Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › EFI RELAY

EFI RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION RELAY (EFI RELAY)

NOTICE:
  1. Some relays are built into the integration relay (unit E). The integration relay cannot be disassembled. If there is a malfunction in the circuit of the integration relay, replace the integration relay.
  2. The internal circuit of the integration relay is as shown in the illustration below. Inspect the integration relay using the following procedures.

A159836E02


Text in Illustration 
*a
Integration Relay (Unit E) Inner Diagram
-
-
  1. Measure the resistance of the EFI fuse.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      EFI fuse
      Always
      Below 1 Ω

      If the result is not as specified, replace the EFI fuse.



    A240717E01
  1. Measure the resistance of the EFI relay circuit.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1C-1 - 1B-4
      When battery voltage is not applied between 1B-2 and 1B-3
      10 kΩ or higher
      When battery voltage is applied between 1B-2 and 1B-3
      Below 1 Ω
      1C-1 - 1B-5
      When battery voltage is not applied between 1B-2 and 1B-3
      10 kΩ or higher
      When battery voltage is applied between 1B-2 and 1B-3
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Integration Relay)
      If the result is not as specified, replace the integration relay.