Home › ENGINE · 3UR-FE › STARTING › STARTER RELAY

STARTER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE STARTER RELAY (ST)
  1. Remove the engine room relay box cover.

  1. Remove the starter relay from the engine room relay block.



2. INSPECT STARTER RELAY


    B060778E26
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Terminal Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



3. INSTALL STARTER RELAY