Home › BODY ELECTRICAL › LIGHTING › AUTOMATIC LIGHT CONTROL SENSOR

AUTOMATIC LIGHT CONTROL SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 SPEAKER HOLE COVER


E281413E01
  1. Put protective tape around the No. 1 speaker hole cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Using moulding remover B, detach the 8 clips.

  1. Disconnect the connector and remove the No. 1 speaker hole cover.



2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


E281414
  1. Detach the 2 claws and remove the automatic light control sensor.