Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > OPERATION CHECK

for Preparation Click here



CHECK ILLUMINATED ENTRY SYSTEM OPERATION
  1. The illuminated entry system controls the following lights:

    1. Transponder key light
    2. Foot light
    3. Roof console box light
    4. Room light

  2. Check the illuminated entry system with the ignition switch OFF.

    1. Check that the lights turn on when unlocking any of the doors that are closed and locked with the ignition switch OFF. Then check that the lights fade out under the following conditions:

      1. Leave the doors unlocked for 15 seconds.
      2. Turn the ignition switch ACC or ON.
      3. Lock all the doors.

    2. Check that the lights stay on for at least 15 seconds after opening any of the doors before fading out. Then check that the lights fade out 15 seconds after closing all the doors.

  3. Check the illuminated entry system with the ignition switch ACC or ON.

    1. Check that the lights stay lit after turning the ignition switch OFF with all the doors closed and the ignition switch ACC or ON. Then check that the lights fade out under the following conditions:

      1. Leave the doors unlocked for 15 seconds.
      2. Turn the ignition switch ACC or ON.
      3. Lock all the doors.

    2. Check that the lights stay on for at least 15 seconds after opening any of the doors. Then check that the lights fade out 15 seconds after closing all the doors.

    3. Check that the lights turn on when opening any of the doors and fade out when closing and locking all the doors or turning the ignition switch ACC or ON.


CHECK BATTERY SAVER OPERATION
  1. Basic function inspection

    1. Turn the ignition switch OFF and close all the doors.

    2. Open the driver side door to turn the room light on, and leave the door open. Check that the light turns off after about 20 minutes.

    3. After the room light turns off, close the driver's door.

    4. Open any door to turn the room light on, and then open another door. Check that the room light turns off within 20 minutes after opening the doors.

  2. Interior light auto cut function inspection

    1. Check that the approximately 20 minutes after the ignition switch was turned off regardless of the open/close status of the doors or the position of the room light switch.


CHECK LIGHT AUTO TURN OFF OPERATION
  1. Turn the ignition switch ON, and turn the light control switch to TAIL or HEAD.

  2. Turn the ignition switch OFF and open the driver door. If the light control switch is TAIL, check that the taillight turns off immediately. If the light control switch is HEAD, check that the headlight and taillight turn off after approximately 30 seconds.

  3. Turn the ignition switch ON, and turn the light control switch to HEAD.

  4. Turn the ignition switch OFF and open the driver's door. Within 30 seconds, lock all the doors. Check that the headlight and taillight turn off immediately.


CHECK DAYTIME RUNNING LIGHT OPERATION (w/ Daytime Running Light)
  1. Check that the turn signal lights turn on when the light control switch is OFF with the engine running and the parking brake released. Then check that the lights turn off under the following conditions:

    1. Turn the light control switch to HEAD or AUTO.