Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

This circuit is used to read the DTCs that are output from the transponder key ECU with the Techstream.

WIRING DIAGRAM


E146442E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - DLC3)


    B128341E03
  1. Disconnect the J26 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J26-9 (D) - J17-7 (SIL)
    Always
    Below 1 Ω
    J26-9 (D) or J17-7 (SIL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BATTERY AND BODY GROUND)


    B124215E14
  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J17-4 (CG) - Body ground
    Always
    Below 1 Ω
    J17-5 (SG) - Body ground

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    J17-16 (BAT) - Body ground
    Always
    11 to 14 V
    J17-7 (SIL) - J17-5 (SG)
    Always
    Pulse generation



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)