Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat)

FRONT SEAT ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT SEAT ASSEMBLY LH
  1. Place the front seat assembly LH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.



    B354548E01
  1. Connect the connector of the front seat airbag assembly LH.
    Text in Illustration 
    *1
    Front Seat Airbag Assembly LH Connector

  1. Connect the 2 connectors and attach the wire harness clamp under the seat.

  1. Align the pin of the front seat with the hole in the vehicle.

  1. Temporarily install the front seat assembly LH with the 4 bolts.

  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B354547
  1. Tighten the 2 bolts.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Operate the seat track adjusting handle to move the seat to the foremost position.



    B354546
  1. Tighten the 2 bolts.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat mounting bolts to adjust the adjuster position.



2. INSTALL INNER SEAT TRACK BRACKET COVER LH
  1. Attach the clip to install the inner seat track bracket cover LH.



3. INSTALL OUTER SEAT TRACK BRACKET COVER LH
  1. Attach the clip to install the outer seat track bracket cover LH.



4. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Install the front seat headrest assembly.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. CHECK SRS WARNING LIGHT
(Click here)


7. INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System)
(Click here)