Home › BODY › SEAT › FRONT POWER SEAT LUMBAR SWITCH

FRONT POWER SEAT LUMBAR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FRONT POWER SEAT LUMBAR SWITCH LH


    B239575E13
  1. Check the resistance of the front power seat lumbar switch LH.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      3 (H) - 5 (B)
      Hold switch on
      Below 1 Ω
      1 (R) - 2 (E)
      2 (E) - 3 (H)
      Neutral
      1 (R) - 2 (E)
      2 (E) - 3 (H)
      Release switch on
      1 (R) - 5 (B)

      If the result is not as specified, replace the front power seat lumbar switch LH.
      Text in Illustration 
      *1
      Hold Switch
      *2
      Release Switch
      *a
      Component without wire harness connected
      (Front Power Seat Lumbar Switch LH)