Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type)

CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type) > INSTALLATION

for Preparation Click here



1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


    B166503
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Install the airbag sensor with the 3 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    1. If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the center airbag sensor.

  1. Connect the holder (with connectors).

  1. Check that the waterproof sheet is properly set.



2. INSTALL FRONT CONSOLE BOX
  1. Install the front console box with the 5 screws <E>.

  1. Install the 2 clips and attach the connector.



3. INSTALL REAR CONSOLE BOX ASSEMBLY
  1. Install the rear console box assembly with the 2 screws <E> and 4 bolts <B>.

  1. Connect the 2 connectors.



4. INSTALL CONSOLE BOX CARPET


5. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY
  1. w/ Power Outlet Socket:
    Attach the 2 wire harness clamps and connect the connector.



    B355390
  1. Attach the 7 clips to install the rear console end panel sub-assembly.



6. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY


    B355387
  1. Attach the 6 clips to install the upper rear console panel sub-assembly.



7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
  1. Attach the 12 clips to install the upper console panel sub-assembly.



8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B355385E01
  1. Twist the shift lever knob sub-assembly in the direction indicated by the arrow to install it.

    HINT:
    1. Tighten the shift lever knob sub-assembly until there is no rotational free-play.
    2. If the leather portion of the knob is not facing forward, tighten the knob further until the leather portion faces forward.

    Text in Illustration 
    *a
    Leather Portion



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).