Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type)

CENTER AIRBAG SENSOR ASSEMBLY (for Floor Shift Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B355384
  1. Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.



4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B355388
  1. Detach the 12 clips and remove the upper console panel sub-assembly.



5. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY
  1. Move the shift lever to N.



    B355386E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover B, detach the 6 clips and remove the upper rear console panel sub-assembly.



6. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY


    B355389
  1. Using a moulding remover B, detach the 7 clips and remove the rear console end panel sub-assembly.

  1. w/ Power Outlet Socket:
    Detach the 2 wire harness clamps and disconnect the connector.



7. REMOVE CONSOLE BOX CARPET


8. REMOVE REAR CONSOLE BOX ASSEMBLY


    B355392
  1. Disconnect the 2 connectors.

  1. Remove the 2 screws <E> and 4 bolts <B> and rear console box assembly.



9. REMOVE FRONT CONSOLE BOX


    B355393
  1. Remove the 2 clips and detach the connector.

  1. Remove the 5 screws <E> and front console box.



10. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


    B166503
  1. Disconnect the holder (with connectors).

  1. Remove the 3 bolts and airbag sensor.