FRONT AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL FRONT AIRBAG SENSOR |
![]() |
Check that the ignition switch is OFF.
Check that the cable is disconnected from the battery negative (-) terminal.
Connect the connector.
Install the front airbag sensor with the nut.
Check that there is no looseness in the installation parts of the front airbag sensor.
| 2. INSTALL BATTERY |
![]() |
Set the battery in the vehicle. Then move the stay onto the battery and tighten the nut to fix the battery in place.
Connect the cable to the positive (+) battery terminal.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).