SIDE AIRBAG SENSOR (for Regular Cab) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side) |
![]() |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
| 4. REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Front Side) |
![]() |
Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel LH.
| *A | for Regular Cab |
| *B | for Double Cab, for CrewMax |
![]() |
Disconnect the master switch connector.
| *A | for Regular Cab |
| *B | for Double Cab, for CrewMax |
| 5. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (for Front Side) |
![]() |
Insert a clip remover between the plate and trim.
Turn the handle clockwise to remove the handle.
| 6. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (for Front Side) |
![]() |
Detach the 3 clips and front lower door frame bracket garnish.
| 7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side) |
![]() |
Remove the 2 screws.
Using a clip remover, remove the clip.
Detach the 10 clips and remove the trim cover. Then disconnect the connector.
![]() |
Disconnect the 2 cables from the inside handle.
Remove the inside handle.
| 8. REMOVE FRONT SIDE AIRBAG SENSOR |
![]() |
Disconnect the connector.
Remove the screw and side airbag sensor.
| 9. REMOVE FRONT DOOR SCUFF PLATE LH (for Rear Side) |
![]() |
Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.
| 10. REMOVE REAR SIDE AIRBAG SENSOR |
![]() |
Remove the bolt and side airbag sensor from the body.
Disconnect the connector.