Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > DISASSEMBLY

for Preparation Click here



1. REMOVE HOOD BULGE ASSEMBLY


B355071E01
  1. Put protective tape around the hood bulge assembly.
    Text in Illustration 
    *1
    Protective Tape



    B355072
  1. Remove the 3 bolts.

  1. Detach the 8 clips and remove the hood bulge assembly.



2. REMOVE HOOD TO RADIATOR SUPPORT SEAL


B355070
  1. Using a clip remover, remove the 10 clips and hood to radiator support seal.



3. REMOVE HOOD INSULATOR (w/ Hood Insulator)


B355069
  1. Using a clip remover, remove the 10 clips.

  1. Detach the 2 guides and remove the hood insulator.



4. REMOVE FRONT WASHER NOZZLE AND HOSE ASSEMBLY


  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched areas shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E146294E01

    If the result is not as specified, replace the washer nozzle.



5. REMOVE WASHER HOSE ASSEMBLY


B355073
  1. Disconnect the washer hose assembly.

  1. Detach the 3 clamps and remove the washer hose assembly.