Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > REASSEMBLY

for Preparation Click here



1. INSTALL WASHER HOSE ASSEMBLY
  1. Attach the 3 clamps to install the washer hose assembly.

  1. Connect the washer hose assembly.



2. INSTALL FRONT WASHER NOZZLE AND HOSE ASSEMBLY


  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched areas shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E146294E01

    If the result is not as specified, replace the washer nozzle.



3. INSPECT FRONT WASHER NOZZLE AND HOSE ASSEMBLY


  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched areas shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E146294E01

    If the result is not as specified, replace the washer nozzle.



4. ADJUST FRONT WASHER NOZZLE AND HOSE ASSEMBLY


    E146295
  1. Using a screwdriver, detach the 2 claws and separate the washer nozzle.

    NOTICE:
    Be careful not to damage the windshield.



    E146296
  1. Remove the washer nozzle from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.



  1. Select a washer nozzle so that the spray is within the standard contact areas. Replace the washer nozzle with the selected one.


    E146297E01



5. INSTALL HOOD INSULATOR (w/ Hood Insulator)
  1. Attach the 2 guides to install the hood insulator.

  1. Install the 10 clips.



6. INSTALL HOOD TO RADIATOR SUPPORT SEAL
  1. Install the hood to radiator support seal with the 10 clips.



7. INSTALL HOOD BULGE ASSEMBLY
  1. Attach the 8 clips to install the hood bulge assembly.

  1. Install the 3 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }