Home › TRANSMISSION ยท A760E AUTOMATIC TRANSMISSION › SHIFT LEVER ASSEMBLY (for Floor Shift Type)

SHIFT LEVER ASSEMBLY (for Floor Shift Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE SHIFT LEVER CAP


    C290576E01
  1. Using a screwdriver, detach the 2 claws and remove the shift lever cap from the upper position indicator housing.
    Text in Illustration 
    *a
    Protective Tape

    NOTICE:
    Be careful not to damage the shift lever cap.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE UPPER POSITION INDICATOR HOUSING


    C290570
  1. Detach the 4 claws and remove the upper position indicator housing from the shift lever assembly.



3. REMOVE POSITION INDICATOR SLIDE COVER


    C290571
  1. Remove the position indicator slide cover together with the No. 2 position indicator slide cover from the shift lever assembly.



4. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER


    C179213
  1. Remove the No. 2 position indicator slide cover from the position indicator slide cover.



5. DISCONNECT INDICATOR LIGHT WIRE SUB-ASSEMBLY


    C292577E01
  1. Using a thin-bladed screwdriver, release the connector housing retainer.
    Text in Illustration 
    *1
    Connector Housing Retainer
    *a
    Component without harness connected
    (Transmission Control Switch)

  1. Using a thin-bladed screwdriver, pull out the 4 (ILL+) and 8 (ILL-) terminals from the rear as shown in the illustration.



    C290574
  1. Detach the 4 guides from the shift lever assembly.



6. REMOVE LOWER POSITION INDICATOR HOUSING


    C290572E01
  1. Using a small screwdriver, detach the 4 claws and remove the lower position indicator housing from the shift lever assembly.
    Text in Illustration 
    *a
    Protective Tape

    NOTICE:
    Be careful not to damage the lower position indicator housing and shift lever assembly.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY


    C290564
  1. Disconnect the connector and remove the indicator light wire sub-assembly from the lower position indicator housing.



8. REMOVE POSITION INDICATOR LED


    C290563
  1. Detach the claw and remove the position indicator LED from the lower position indicator housing.



9. REMOVE SHIFT LOCK CONTROL ECU


    C179217
  1. Disconnect the shift lock solenoid connector.

  1. Detach the 3 claws and remove the shift lock control ECU from the shift lever assembly.