SHIFT LEVER ASSEMBLY (for Floor Shift Type) > REASSEMBLY |
| 1. INSTALL SHIFT LOCK CONTROL ECU |
Attach the 3 claws to install the shift lock control ECU to the shift lever assembly.
Connect the shift lock solenoid connector.
| 2. INSTALL POSITION INDICATOR LED |
Attach the claw to install the position indicator LED to the lower position indicator housing.
| 3. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY |
Connect the connector and install the indicator light wire sub-assembly to the lower position indicator housing.
| 4. INSTALL LOWER POSITION INDICATOR HOUSING |
![]() |
Attach the 4 claws to install the lower position indicator housing to the shift lever assembly.
| 5. CONNECT INDICATOR LIGHT WIRE SUB-ASSEMBLY |
Attach the 4 guides.
![]() |
Securely connect the 2 wire terminals to terminals 4 (ILL+) and 8 (ILL-) of the transmission control switch connector. Then push the connector housing retainer to lock it.
| *1 | Connector Housing Retainer |
| *a | Component without harness connected (Transmission Control Switch) |
| 6. INSTALL NO. 2 POSITION INDICATOR SLIDE COVER |
Install the No. 2 position indicator slide cover to the position indicator slide cover.
| 7. INSTALL POSITION INDICATOR SLIDE COVER |
Install the position indicator slide cover with the No. 2 position indicator slide cover to the shift lever assembly.
| 8. INSTALL UPPER POSITION INDICATOR HOUSING |
Attach the 4 claws to install the upper position indicator housing to the shift lever assembly.
| 9. INSTALL SHIFT LEVER CAP |
![]() |
Attach the 2 claws to install the shift lever cap to the shift lever assembly.