DTC P060A Internal Control Module Monitoring Processor Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P060A | When either condition below is met:
| ECM |
| Related DTCs | None |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of operation | Once per driving cycle |
| Duration | - |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| When either condition below is met: | Condition 1 or 2 |
| 1. When all conditions below are met: | - |
| - CPU reset | 1 time or more |
| - Learned TP - Learned APP | 0.4 V or more |
| - Electronic throttle actuator | OFF |
| 2. CPU reset | 2 times or more |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK DTC |
Clear DTC (Click here).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON.
Check DTC.
|
| ||||
| OK | ||
| ||