Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER RELAY

HEADLIGHT DIMMER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER RELAY


E281421
  1. Remove the headlight dimmer relay from the engine room relay box.



    E277741E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied to terminals 1 and 2
      10 kΩ or higher
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω
      3 - 4
      Battery voltage not applied to terminals 1 and 2
      Below 1 Ω
      Battery voltage applied to terminals 1 and 2
      10 kΩ or higher

      If the result is not as specified, replace the headlight dimmer relay.

  1. Install the headlight dimmer relay to the engine room relay box.