Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT RELAY

FOG LIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FOG LIGHT RELAY


E281419
  1. Remove the fog light relay from the engine room relay box.



    E277744E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied to terminals 1 and 2
      10 kΩ or higher
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the fog light relay.

  1. Install the fog light relay to the engine room relay box.