Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK COMBINATION METER

E146387E01

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J28-1 (B) - Body ground
    LG - Body ground
    Power source
    Always
    11 to 14 V
    J28-2 (IG+) - Body ground
    P - Body ground
    Ignition switch signal
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    11 to 14 V
    J28-3 (BZ) - Body ground*1
    V - Body ground
    Clearance warning buzzer
    Clearance warning buzzer sounding (when the back sonar or clearance sonar sensors something)
    Pulse generation
    J28-4 (BK) - Body ground*1
    BE - Body ground
    Ultrasonic sensor (for rear corner LH and RH)
    Clearance warning indicator for back right and left sensor illuminates
    Below 3 V
    J28-5 (OP) - Body ground*1
    R - Body ground
    Clearance warning ECU signal
    Clearance warning indicator's operation indicator illuminates
    Below 3 V
    J28-6 (FR) - Body ground
    B - Body ground
    Ultrasonic sensor (for front corner RH)
    Clearance warning indicator for front corner RH illuminates
    Below 3 V
    J28-7 (FL) - Body ground*1
    LG - Body ground
    Ultrasonic sensor (for front corner LH)
    Clearance warning indicator for front corner LH illuminates
    Below 3 V
    J28-8 (RR) - Body ground*1
    G - Body ground
    Ultrasonic sensor (for rear corner RH)
    Clearance warning indicator for rear corner RH illuminates
    Below 3 V
    J28-9 (RL) - Body ground*1
    GR - Body ground
    Ultrasonic sensor (for rear corner LH)
    Clearance warning indicator for rear corner LH illuminates
    Below 3 V
    J28-10 (CHK) - Body ground
    R - Body ground
    MIL input signal
    Ignition switch ON, MIL ON
    Below 3 V
    Ignition switch OFF, MIL OFF
    11 to 14 V
    J28-12 (CHG-) - Body ground
    B - Body ground
    CHARGE warning light
    Ignition switch ON, CHARGE warning light ON
    Below 1 V
    Ignition switch ON, CHARGE warning light OFF
    11 to 14 V
    J28-13 (TIRE) - Body ground
    LG - Body ground
    Tire pressure warning light input signal
    Ignition switch ON, tire pressure warning light ON
    Below 1.5 V
    Ignition switch ON, tire pressure warning light OFF
    8 V or higher
    J28-14 (SW) - Body ground
    R - Body ground
    Brake fluid level warning light signal
    Ignition switch ON, Brake warning light ON
    Below 1 V
    Ignition switch ON, Brake warning light OFF
    11 to 14 V
    J28-15 (WLVL) - Body ground
    P - Body ground
    Washer level warning
    Ignition switch ON, Washer level warning ON
    Below 1 V
    Ignition switch ON, Washer level warning OFF
    11 to 14 V
    J28-16 (B) - Body ground
    B - Body ground
    Turn signal L
    Ignition switch ON, turn signal switch neutral position
    Below 1 V
    Ignition switch ON, turn signal switch turned to left
    Alternating between below 1 V and 11 to 14 V
    J28-17 (B) - Body ground
    G - Body ground
    Turn signal R
    Ignition switch ON, turn signal switch neutral position
    Below 1 V
    Ignition switch ON, turn signal switch turned to right
    Alternating between below 1 V and 11 to 14 V
    J28-22 (ILL-) - Body ground
    W - Body ground
    Illumination signal
    Headlight dimmer switch in neither tail nor head position
    Below 1 V
    Headlight dimmer switch in tail or head position
    11 to 14 V
    J28-23 (EP) - Body ground
    W-B - Body ground
    Illumination ground
    Always
    Below 1 Ω
    J28-24 (ES) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    J28-25 (E3) - Body ground
    Y - Body ground
    Fuel sender gauge ground
    Always
    Below 1 Ω
    J28-26 (L) - J28-25 (E3)
    V - Y
    Fuel sender gauge
    Ignition switch ON, fuel sender gauge ON
    Below 1 V
    Ignition switch ON, fuel sender gauge OFF
    11 to 14 V
    J28-27 (S) - Body ground
    L - Body ground
    Oil pressure warning
    Ignition switch ON, oil pressure warning ON
    Below 1 V
    Ignition switch ON, oil pressure warning OFF
    11 to 14 V
    J28-29 (+S) - Body ground
    V - Body ground
    Speed signal (output)
    Ignition switch ON, wheel turned slowly
    Pulse generation
    J28-30 (SI) - Body ground
    LG - Body ground
    Speed signal (input)
    Ignition switch ON, wheel turned slowly
    Pulse generation
    J28-31 (P) - Body ground
    GR - Body ground
    A/T shift position signal P
    Ignition switch ON, shift lever is except P position
    Below 1 V
    Ignition switch ON, shift lever is P position
    11 to 14 V
    J28-32 (R) - Body ground
    BR - Body ground
    A/T shift position signal R
    Ignition switch ON, shift lever is except R position
    Below 1 V
    Ignition switch ON, shift lever is R position
    11 to 14 V
    J28-33 (N) - Body ground
    L - Body ground
    A/T shift position signal N
    Ignition switch ON, shift lever is except N position
    Below 1 V
    Ignition switch ON, shift lever is N position
    11 to 14 V
    J28-34 (D) - Body ground
    G - Body ground
    A/T shift position signal D
    Ignition switch ON, shift lever is except D position
    Below 1 V
    Ignition switch ON, shift lever is D position
    11 to 14 V
    J28-35 (4) - Body ground
    P - Body ground
    A/T shift position signal S
    Ignition switch ON, shift lever is except S position
    Below 1 V
    Ignition switch ON, shift lever is S position
    11 to 14 V
    J28-36 (MSSL) - Body ground*2
    V - Body ground
    DISP switch signal
    Ignition switch ON, DISP switch OFF
    10 kΩ or higher
    Ignition switch ON, DISP switch ON
    Below 1 Ω
    J28-37 (LP) - Body ground*3
    L - Body ground
    Security indicator light signal
    Immobiliser set status (SET)
    Alternating between 11 to 14 V and below 1 V
    Immobiliser set status (UNSET)
    Below 1 V

    1. *1: w/ Intuitive Parking Assist System
    2. *2: for TFT Display Type
    3. *3: w/ Engine Immobiliser System


CHECK COMBINATION METER INNER CIRCUIT

E282488E01


E282489E01


E282490E01


E282491E01