Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Body Electrical, Powertrain or Chassis / (desired system) / Data List.

  5. According to the display on Techstream, read the "Data List".

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ODO/TRIP Change SW
    Trip switch (ODO/TRIP switch) condition/ON or OFF
    ON: Trip switch (ODO/TRIP switch) pushed
    OFF: Trip switch (ODO/TRIP switch) not pushed
    -
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 (0), Max.: 255 (158)
    Almost same as actual vehicle speed (when driving)
    Unit: km/h (mph)
    Engine Rpm
    Engine speed/Min.: 0, Max.: 12750
    Idling: 700 to 800
    Unit: rpm
    Coolant Temperature
    Engine coolant temperature/Min.: -40 (-40), Max.: 140 (284)
    After warming up: 80 to 105 (176 to 221)
    1. Unit: °C (°F)
    2. If value -40 (-40): sensor circuit open
    3. If value 140 (284): sensor circuit shorted
    Washer Switch
    Washer fluid level warning signal/ON or OFF
    ON: Washer fluid level low
    OFF: Washer fluid level not low
    -
    Multi Display Select Switch*
    Steering pad switch (DISP)/ON or OFF
    ON: Steering pad switch (DISP) pressed
    OFF: Steering pad switch (DISP) not pressed
    -
    +B Voltage Value
    +B voltage/Min.: 0, Max.: 25.5
    Below 1 to 14
    Unit: V
    Integrated value for Maintenance
    Integrated value for oil maintenance warning/Min.: 0 (0), Max.: 25500 (41037)
    0 (0) to 25500 (41037)
    Unit: mile (km)
    Ambient Temperature
    Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F)
    Almost the same as actual outside temperature
    -
    Rheostat value
    Light control rheostat switch input/Min.: 0, Max.: 100
    Light control rheostat switch is Dark (0) → Bright (100)
    Unit: %
    TPMS Operation State
    The condition of the tire pressure/OFF, ON or Unknown
    OFF: Tire pressure warning system not operated
    ON: Tire pressure warning system operated
    Unknown: Wire harness between combination meter assembly and tire pressure warning ECU open
    -
    Fuel Level
    Fuel sender gauge input/Min.: 0, Max.: 127.5
    Fuel sender input value
    Unit: L
    Key Remind Sound
    Key reminder sound/FAST, NORMAL or SLOW
    Displays key reminder buzzer speed setting
    -
    Key Remind Volume
    Key reminder volume/LARGE, MEDIUM or SMALL
    Displays key reminder buzzer volume setting
    -
    Driver Side Seatbelt Warning Buzzer
    Driver side seat belt warning buzzer setting/ON or OFF
    ON: Driver side seat belt warning buzzer ON setting
    OFF: Driver side seat belt warning buzzer OFF setting
    -
    P-Seatbelt Warning Buzzer
    Front passenger side seat belt warning buzzer setting/ON or OFF
    ON: Front passenger side seat belt warning buzzer ON setting
    OFF: Front passenger side seat belt warning buzzer OFF setting
    -
    ODO Display Time After IG OFF Setting
    Odometer display time setting/30 s, 60 s, 600 s or OFF
    Displays odometer display time setting
    -
    Number of Trouble Code
    Number of DTCs currently stored
    0
    -

    1. *: for TFT Display Type

    Engine and ECT: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/Min.: 0, Max.: 16383.75
    Idling: 700 to 800
    Unit: rpm
    Vehicle Speed
    Vehicle speed/Min.: 0 (0), Max.: 255 (158)
    Actual vehicle speed
    1. Unit: km/h (mph)
    2. Speed indicated on speedometer
    Coolant Temp
    Engine coolant temperature/Min.: -40 (-40), Max.: 215 (419)
    After warming up: 80 to 105 (176 to 221)
    1. Unit: °C (°F)
    2. If value -40 (-40): sensor circuit open
    3. If value 215 (419): sensor circuit shorted

    ABS/VSC/TRAC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    (FL/FR/RL/RR) Wheel Speed
    Wheel speed sensor (FL/FR/RL/RR) reading/Min.: 0 (0), Max.: 326 (202)
    Actual wheel speed
    Similar speed as indicated on speedometer


ACTIVE TEST

HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Body Electrical / (desired system) / Active Test.

  5. According to the display on Techstream, perform the "Active Test".

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation*1
    Speedometer
    0, 40, 80, 120, 160 or 200
    Perform the test with the vehicle stopped and engine idling
    Acceptable range (km/h or mph): [Control range → Speedometer display]
    for mph
    1. 40 mph → 39 to 42.5 mph
    2. 80 mph → 79.5 to 84 mph
    3. 120 mph → 120 to 125.5 mph
    for km/h
    1. 40 km/h → 41.7 to 46.2 km/h
    2. 80 km/h → 83.4 to 88.4 km/h
    3. 120 km/h → 125.1 to 130.6 km/h
    4. 160 km/h → 166.2 to 173.2 km/h
    5. 200 km/h → 207.7 to 215.7 km/h
    Tacho Meter Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000
    Perform the test with the vehicle stopped and engine idling
    Fuel Meter Operation
    Fuel receiver gauge
    OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full or Sender F
    Perform the test with the vehicle stopped and engine idling
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    OFF, LOW, NORMAL or HIGH
    Perform the test with the vehicle stopped and engine idling
    Volt Meter Operation*3
    Voltmeter
    OFF, 0V, 3V, 6V, 9V, 12V, 15V or 18V
    Perform the test with the vehicle stopped and engine idling
    Oil Pressure Meter Operation*3
    Oil pressure receiver gauge
    OFF, LOW, 1/4, 1/2, 3/4 or HIGH
    Perform the test with the vehicle stopped and engine idling
    A/T Indicator operation 1
    A/T indicator (normal mode)
    OFF, L, 2, 3(M), 4(M), D, N, R or P
    Perform the test with the vehicle stopped and engine idling
    A/T Indicator operation 2
    A/T indicator (sequential mode)
    OFF, 5*4, 6*5 or Es
    Perform the test with the vehicle stopped and engine idling
    Meter Display 1
    Multi-information display
    0*2, 1*2, 2*2, 3*2, 4*2, 5*2, 6*2, 7*2, 8*2, 9*2, ALL or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Airbag
    SRS warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Doors All Open
    DOOR indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Driver Side Seat Belt
    Front seat belt warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp ABS
    ABS warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    VSC TRC Indicator*2
    TRAC OFF indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Slip
    SLIP indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Beam
    BEAM indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Head*6
    HEAD indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp TAIL*7
    TAIL indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Fuel
    Low fuel warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Tire Pressure Warning System
    Tire pressure warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    A/T Oil Temperature Operation*2
    A/T OIL TEMP warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. 4WD*8
    4HI indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. 4LO*8
    4LO indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Cruise*9
    Cruise control indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. SET*9
    SET indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Brake
    Brake warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Oil Maintenance*2*6
    Oil maintenance indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Master Warning*3
    Master warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Auto LSD
    AUTO LSD indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    TOW HAUL Indicator
    TOW HAUL indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Lamp Washer*2
    Washer fluid level warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. Oil Pressure*2
    Oil pressure warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling
    Indicat. VSC OFF
    VSC OFF indicator light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling

    1. *1:
      1. It is normal that door will be locked automatically when performing the speedometer Active Test.
      2. The displayed value has the same units (km/h, mph) as the main scale of the vehicle's speedometer.
      3. The needle position should be within the acceptable tolerance.
    2. *2: for LCD Display Type
    3. *3: for TFT Display Type
    4. *4: for 1GR-FE
    5. *5: for 1UR-FE, 3UR-FE, 3UR-FBE
    6. *6: for U.S.A.
    7. *7: except U.S.A.
    8. *8: for 4WD
    9. *9: w/ Cruise Control System