Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH TECHSTREAM

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream ON.

  4. Enter the following menus: Customize Setting.

  5. Select the setting by referring to the table below.

    Warning: 
    Display (Item)
    Default
    Contents
    Setting
    Key Remind Volume
    Large
    To change volume of key reminder buzzer
    Large / Medium / Small
    Key Remind Sound
    Slow
    To change frequency of key reminder buzzer
    Slow / Fast / Normal
    Driver Side Seatbelt Warning Buzzer
    ON
    To change setting of driver side seat belt warning buzzer
    ON / OFF
    Front Passenger Side Seatbelt Warning Buzzer
    ON
    To change setting of front passenger side seat belt warning buzzer
    ON / OFF

    Display: 
    Display (Item)
    Default
    Contents
    Setting
    ODO Display Time After IG OFF Setting
    30 s
    To change setting of odometer display time
    30 s / 60 s / 600 s / OFF


CUSTOMIZING FUNCTION WITH MULTI-INFORMATION DISPLAY (for TFT Display Type)
  1. Using the DISP switch, the following functions can be customized through the multi-information display.

    1. Turn by turn navigation setting
    2. Language setting
    3. Units setting