Home › BODY ELECTRICAL › LIGHTING › CARGO LIGHT SWITCH

CARGO LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT DECK LIGHT SWITCH ASSEMBLY


E145554E02
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      5 (CCTY) - 9 (CGON)
      Cargo light switch ON
      Below 1 Ω
      Cargo light switch DOOR
      Cargo light switch OFF
      10 kΩ or higher
      10 (CGLP) - 7 (E)
      Cargo light switch ON
      Below 1 Ω
      Cargo light switch DOOR
      10 kΩ or higher
      Cargo light switch OFF

      If the result is not as specified, replace the deck light switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Deck Light Switch Assembly)



    E145554E03
  1. Check the illumination.

    1. Apply battery voltage to the connector and check the illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1 (ILL+)
      Battery negative (-) → Terminal 4 (ILL-)
      Illuminates

      If the result is not as specified, replace the deck light switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Deck Light Switch Assembly)