FUEL SENDER GAUGE ASSEMBLY > INSTALLATION |
| 1. INSTALL FUEL SENDER GAUGE ASSEMBLY |
![]() |
Slide the fuel sender gauge onto the fuel suction support to install it.
![]() |
Attach the 2 claws to connect the wire harness.
![]() |
Insert the 2 wire terminals into the connector.
![]() |
Attach the 2 claws to install the cover to the back end of the connector, and then install the cap.
![]() |
Connect the connector to the fuel suction plate.
| 2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
Install the fuel suction with pump and gauge tube assembly (Click here).