Home › BODY › WINDSHIELD / WINDOWGLASS › WINDSHIELD DEICER SYSTEM

WINDSHIELD DEICER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK AIR CONDITIONING AMPLIFIER

B160781E01

  1. Disconnect the J19 air conditioning amplifier connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J19-1 (IG+) - J19-14 (GND)
    P - W-B
    Ignition power supply
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V
    J19-21 (B) - J19-14 (GND)
    BR - W-B
    Battery power source
    Always
    11 to 14 V
    J19-37 (LIN1) - J19-14 (GND)
    SB - W-B
    LIN communication signal
    Ignition switch ON
    Pulse generation
    J19-14 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

  3. Reconnect the J19 air conditioning amplifier connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J19-40 (D) - J19-14 (GND)
    GR - W-B
    Deicer relay
    Ignition switch ON, windshield deicer switch off
    11 to 14 V
    Ignition switch ON, windshield deicer switch on
    Below 1 V


CHECK AIR CONDITIONING CONTROL ASSEMBLY

E280655E01

  1. Disconnect the J127 air conditioning control assembly connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J127-4 (IG+) - J127-5 (GND)
    SB - W-B
    Ignition power supply
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V
    J127-5 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    J127-7 (STX) - J127-5 (GND)
    SB - W-B
    LIN communication signal
    Ignition switch ON
    Pulse generation