Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > TERMINALS OF ECU



CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)

E146648E03

  1. Disconnect the DA, DB, and J4 ECU connectors.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    DA-1 (ACC) - Body ground
    B - Body ground
    ACC power supply
    Always
    11 to 14 V
    DA-1 (IG) - Body ground
    B - Body ground
    IG power supply
    Always
    11 to 14 V
    DA-1 (ALTB) - Body ground
    B - Body ground
    +B power supply
    Always
    11 to 14 V
    DB-13 (BECU) - Body ground
    GR - Body ground
    BECU power supply
    Always
    11 to 14 V
    DB-21 (GND1) - Body ground
    B - Body ground
    Body ground
    Always
    Below 1 Ω
    DB-21 (GND2) - Body ground
    B - Body ground
    Body ground
    Always
    Below 1 Ω
    J4-16 (HCTY) - Body ground
    V - Body ground
    Engine hood courtesy switch signal
    Engine hood closed
    10 kΩ or higher
    Engine hood open
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the DA, DB and J4 ECU connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J1-4 (IND) - Body ground
    P - Body ground
    Security indicator signal
    Security indicator illuminates
    (illuminates only for 60 sec. in alarm sounding state (it is blinking when system is in armed state))
    3 to 5 V
    J1-6 (SH) - Body ground
    W - Body ground
    Security horn signal
    Armed state
    Below 1 V
    Security horn is sounding
    (theft deterrent system is in alarm sounding state)
    Pulse generation
    J2-4 (HAZ) - Body ground
    BE - Body ground
    Hazard warning light signal
    Armed state
    Below 1 V
    System is in alarm sounding state
    Pulse generation
    J4-17 (GBS)* - Body ground
    L - Body ground
    Glass breakage sensor ECU signal
    Armed state
    Below 1 V
    Glass breakage sensor ECU signal system is in alarm sounding state
    Pulse generation
    DB-1 (HORN) - Body ground
    V - Body ground
    Horn signal
    (low pitched and high pitched)
    Armed state
    Below 1 V
    Horn is sounding
    11 to 14 V

    HINT:
    *: w/ Glass Breakage Sensor

    If the result is not as specified, there may be a malfunction on the wire harness side, or the glass breakage sensor ECU may have a malfunction.