Home › ENGINE · 1GR-FE › STARTING › ACC CUT RELAY

ACC CUT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACC CUT RELAY


    A087121E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    When battery voltage is applied to terminals 1 and 2
    10 kΩ or higher

    If the result is not as specified, replace the ACC Cut relay.