Home › BODY › ENGINE HOOD / DOOR › HOOD SUPPORT

HOOD SUPPORT > DISPOSAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. DISPOSE OF HOOD SUPPORT ASSEMBLY LH


    B166020E04
  1. Horizontally secure the hood support assembly LH in a vise with the piston-rod pulled out.

  1. Using a metal saw, gradually cut anywhere in the area labeled A to release the gas.
    Standard 
    Area
    Specified Condition
    A
    200 mm (7.87 in.)

    CAUTION:
    As metal debris may be blown outward by the gas, you must:
    1. Wear protective glasses.
    2. Cover the area being cut.

    NOTICE:
    The gas inside the hood support assembly LH is colorless, odorless and harmless. As there is a possibility that metal debris could scatter, cover the hood support assembly LH with a piece of cloth or other material.