Home › BODY › ENGINE HOOD / DOOR › HOOD SUPPORT

HOOD SUPPORT > INSTALLATION

for Preparation Click here


CAUTION:
Install the hood support assembly LH while holding the hood.

NOTICE:
  1. Do not touch the extendable portion of the rod to prevent foreign objects from attaching to the hood support assembly LH surface.
  2. Do not push the hood support assembly LH sideways because the hood support assembly LH may bend.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL NO. 1 HOOD SUPPORT BOLT


    B354834
  1. Install the No. 1 hood support bolt.

    Torque:
    22 N*m{ 224 kgf*cm , 16 ft.*lbf }

    CAUTION:
    Install the No. 1 hood support bolt while supporting the hood by hand.



2. INSTALL HOOD SUPPORT ASSEMBLY LH


B354835
  1. Install the 2 stop rings to the hood support assembly LH.

  1. Attach the 2 ball joints to install the hood support assembly LH.

  1. Check that the hood support assembly LH is connected to the ball joint and cannot be pulled off.

    CAUTION:
    Install the hood support assembly LH while holding the hood.

    NOTICE:
    Check that the hood support assembly LH is engaged in the ball joint and it cannot be pulled out.