Home › BODY › ENGINE HOOD / DOOR › HOOD SUPPORT

HOOD SUPPORT > REMOVAL

for Preparation Click here


CAUTION:
Remove the hood support assembly LH while holding the hood.

NOTICE:
  1. Do not touch the extendable portion of the rod to prevent foreign objects from attaching to the hood support assembly LH surface.
  2. Do not push the hood support assembly LH sideways because the hood support assembly LH may bend.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE HOOD SUPPORT ASSEMBLY LH


    B354833E01
  1. Using a screwdriver, remove the 2 stop rings as indicated by the arrows in the order shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

    CAUTION:
    Remove the hood support assembly LH while holding the hood.

    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 2 ball joints and then remove the hood support assembly LH.



2. REMOVE NO. 1 HOOD SUPPORT BOLT


    B354834
  1. Remove the No. 1 hood support bolt.