HOOD > ADJUSTMENT |

| 1. ADJUST HOOD SUB-ASSEMBLY |
![]() |
Adjust the hood sub-assembly position.
Loosen the 4 hinge bolts.
Move the hood sub-assembly and adjust the clearance between the hood sub-assembly and front fender.
Tighten the 4 hinge bolts after the adjustment.
![]() |
Adjust the cushion rubber so that the height of the hood sub-assembly and fender are aligned.
Adjust the hood lock assembly.
![]() |
Using a screwdriver, remove the hood lock nut cap as shown in the illustration.
| *1 | Protective Tape |
![]() |
Loosen the 2 bolts and hood lock bolt.
Adjust the hood lock assembly position so that the striker can enter it smoothly.
Tighten the bolts after the adjustment.
Install a new hood lock nut cap.