REAR DOOR (for CrewMax) > DISASSEMBLY |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH |
![]() |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
| 4. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH |
![]() |
Using a moulding remover A, detach the 2 clips and 5 claws, and remove the rear upper door armrest base panel LH.
![]() |
Disconnect the connector.
| 5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY |
![]() |
Detach the 2 claws and remove the rear power window regulator switch assembly.
| 6. REMOVE REAR DOOR FRAME GARNISH LH |
![]() |
Detach the 5 clips and remove the rear door frame garnish.
| 7. REMOVE REAR DOOR ARMREST COVER LH |
| 8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Remove the 2 screws.
Using a clip remover, remove the clip.
for Standard:
Detach the 10 clips and remove the trim board.
for 12 Speakers:
Detach the 10 clips and remove the trim board. Then disconnect the connector.
![]() |
Disconnect the 2 cables from the inside handle.
Remove the inside handle.
| 9. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 12 Speakers) |

| *A | for Standard | *B | for 12 Speakers |
Detach the 3 claws and remove the rear No. 2 speaker assembly.
| 10. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH |
| 11. REMOVE REAR NO. 2 DOOR TRIM BRACKET |
![]() |
Remove the 2 screws and bracket.
| 12. REMOVE REAR SPEAKER ASSEMBLY |
Remove the 3 screws.

| *A | for Standard | *B | for 12 Speakers |
Disconnect the connector and remove the rear No. 1 speaker assembly.
| 13. REMOVE REAR DOOR SERVICE HOLE COVER LH |
![]() |
Disconnect the connector and 5 clamps.
Remove the rear door service hole cover.
| 14. REMOVE REAR DOOR GLASS RUN LH |
![]() |
Remove the rear door glass run.
| 15. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts and rear door rear lower window frame.
| 16. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH |
![]() |
Temporarily install the power window regulator switch.
Move the door glass until the bolts appear in the service holes.
Remove the 2 bolts.
Remove the rear door glass from the rear door window regulator as shown in the illustration.
Remove the power window regulator switch.
| 17. REMOVE REAR DOOR FRONT WINDOW GUIDE SUB-ASSEMBLY LH |
![]() |
Remove the 2 bolts and rear lower front door window guide.
| 18. REMOVE REAR NO. 2 DOOR GLASS RUN LH |
Remove the rear door glass run from the rear front lower door window guide.
| 19. REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP |
![]() |
Put protective tape around the weatherstrip outer.
Using a moulding remover, detach the claw and remove the weatherstrip.
| 20. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH |
![]() |
Disconnect the connector.
Loosen the temporary bolt.
Remove the 5 bolts and window regulator.
Remove the window regulator through the service hole.
Remove the temporary bolt from the door window regulator.
| 21. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
![]() |
Using a T25 "TORX" driver, remove the 3 screws and motor.
| 22. REMOVE REAR DOOR LOCK ASSEMBLY LH |
![]() |
Disconnect the connector.
Using a T30 "TORX" wrench, remove the 3 screws and door lock.
| 23. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH |
![]() |
Using a screwdriver, detach the claw.
![]() |
Remove the rear door lock remote control cable.
| 24. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH |
![]() |
Using a screwdriver, detach the 3 claws.
![]() |
Remove the rear door inside locking cable.
| 25. REMOVE REAR DOOR LOCK CHILD PROTECTION COVER LH |
| 26. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH |
![]() |
Remove the hole plug.
Using a T30 "TORX" wrench, loosen the screw and remove the rear door outside handle cover.
Remove the cover.
| 27. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH |
![]() |
Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.
| 28. REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH |
![]() |
Remove the front and rear outside handle pads .
Using a T30 "TORX" wrench, loosen the screw.
Slide the outside handle frame to remove it.
| 29. REMOVE REAR DOOR LOCK OPEN ROD LH |
Remove the lock open rod from the outside handle frame.
| 30. REMOVE REAR NO. 2 DOOR WEATHERSTRIP LH |
![]() |
Using a clip remover, detach the 10 clips and remove the weatherstrip.
| 31. REMOVE REAR DOOR CHECK ASSEMBLY LH |
![]() |
Remove the bolt, 2 nuts and door check.
| 32. REMOVE REAR DOOR WEATHERSTRIP LH |
![]() |
Using a clip remover, detach the 2 clips.
![]() |
Using a clip remover, detach the 41 clips and remove the weatherstrip.