Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER (for Regular Cab)

DOOR CONTROL RECEIVER (for Regular Cab) > REMOVAL

for Preparation Click here



1. REMOVE UPPER BACK PANEL GARNISH


B164740
  1. Detach the 10 clips and remove the upper back panel garnish.



2. REMOVE LUGGAGE COMPARTMENT BOX LH


B164747
  1. Remove the 2 clips.

  1. Detach the 3 claws and remove the luggage compartment box LH.



3. REMOVE LUGGAGE COMPARTMENT BOX RH


B164748
  1. Remove the 4 clips and luggage compartment box RH.



4. REMOVE FRONT DOOR SCUFF PLATE RH
  1. Remove the front door scuff plate .

    HINT:
    The procedures listed below are for the LH side.



5. REMOVE COWL SIDE TRIM BOARD RH
  1. Remove the cowl side trim board .

    HINT:
    The procedures listed below are for the LH side.



6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
  1. Remove the front door opening trim weatherstrip .

    HINT:
    The procedures listed below are for the LH side.



7. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH


B164750
  1. Detach the 2 claws and remove the cover.



    B164749
  1. Loosen the bolt and disconnect the front seat outer belt assembly RH.



    B355510
  1. Push the 2 locks and remove the trim cover.

  1. Remove the jack assembly.



    B355511
  1. Detach the 9 clips and remove the lower quarter trim panel assembly RH.



8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
  1. Remove the front quarter trim panel assembly .

    HINT:
    The procedures listed below are for the LH side.



9. REMOVE DOOR CONTROL RECEIVER


B164741E01
  1. Disconnect the connector.

  1. Remove the bolt and door control receiver.