Home › BODY ELECTRICAL › OTHER SYSTEM › POWER OUTLET SOCKET

POWER OUTLET SOCKET > INSTALLATION

for Preparation Click here



1. INSTALL POWER OUTLET SOCKET COVER
  1. Attach the 2 claws to install the power outlet socket cover.

    HINT:
    Use the same procedure described for the another side.



2. INSTALL POWER OUTLET SOCKET ASSEMBLY
  1. Attach the 2 claws to install the power outlet socket assembly.

    HINT:
    Use the same procedure described for the another side.



3. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
  1. Attach the 3 clips to install the lower center instrument panel finish panel to the air conditioning control assembly.



4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY WITH LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    E281401E01
  1. Attach the 3 clips to install the air conditioning control assembly to the center lower instrument panel finish panel.
    Text in Illustration 
    *1
    Air Conditioning Control Assembly
    *2
    Center Lower Instrument Panel Finish Panel



  1. Put protective tape around the air conditioning control assembly.


    E281400E01


    Text in Illustration 
    *A
    for Automatic Air Conditioning System
    *B
    for Manual Air Conditioning System
    *1
    Protective Tape
    *2
    Air Conditioning Control Assembly
    *3
    Center Lower Instrument Panel Finish Panel
    -
    -

  1. Connect each connector.

  1. Attach the 8 clips, 2 claws and guide to install the air conditioning control assembly together with the center lower instrument panel finish panel.



5. INSTALL FRONT CONSOLE BOX (for Floor Shift Type)
  1. Install the front console box with the 5 screws <E>.

  1. Install the 2 clips and attach the connector.



6. INSTALL REAR CONSOLE BOX ASSEMBLY (for Floor Shift Type)


    B355387
  1. Attach the 6 clips to install the upper rear console panel sub-assembly.



7. INSTALL CONSOLE BOX CARPET (for Floor Shift Type)
  1. Install the console box carpet.



8. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY (for Floor Shift Type)
  1. w/ Power Outlet Socket:
    Attach the 2 wire harness clamps and connect the connector.



    B355390
  1. Attach the 7 clips to install the rear console end panel sub-assembly.



9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Floor Shift Type)
  1. Attach the 12 clips to install the upper console panel sub-assembly.



10. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY (for Floor Shift Type)


    B355387
  1. Attach the 6 clips to install the upper rear console panel sub-assembly.



11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Floor Shift Type)


    B355385E01
  1. Twist the shift lever knob sub-assembly in the direction indicated by the arrow to install it.

    HINT:
    1. Tighten the shift lever knob sub-assembly until there is no rotational free-play.
    2. If the leather portion of the knob is not facing forward, tighten the knob further until the leather portion faces forward.

    Text in Illustration 
    *a
    Leather Portion



12. INSTALL LOWER CENTER INSTRUMENT COVER (for Column Shift Type)
  1. Attach the 2 guides and 2 clips to install the lower center instrument cover.

  1. Install the 2 clips.