Home › BODY ELECTRICAL › OTHER SYSTEM › POWER OUTLET SOCKET

POWER OUTLET SOCKET > REMOVAL

for Preparation Click here



1. REMOVE LOWER CENTER INSTRUMENT COVER (for Column Shift Type)


    B355335
  1. Remove the 2 clips.

  1. Detach the 2 clips, 2 guides and remove the lower center instrument cover.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Floor Shift Type)


    B355384
  1. Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.



3. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY (for Floor Shift Type)
  1. Move the shift lever to N.



    B355386E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover B, detach the 6 clips and remove the upper rear console panel sub-assembly.



4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Floor Shift Type)


    B355388
  1. Detach the 12 clips and remove the upper console panel sub-assembly.



5. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY (for Floor Shift Type)


    B355389
  1. Using a moulding remover B, detach the 7 clips and remove the rear console end panel sub-assembly.

  1. w/ Power Outlet Socket:
    Detach the 2 wire harness clamps and disconnect the connector.



6. REMOVE CONSOLE BOX CARPET (for Floor Shift Type)


B355391
  1. Remove the console box carpet.



7. REMOVE REAR CONSOLE BOX ASSEMBLY (for Floor Shift Type)


    B355392
  1. Disconnect the 2 connectors.

  1. Remove the 2 screws <E> and 4 bolts <B> and rear console box assembly.



8. REMOVE FRONT CONSOLE BOX (for Floor Shift Type)


    B355393
  1. Remove the 2 clips and detach the connector.

  1. Remove the 5 screws <E> and front console box.



9. REMOVE AIR CONDITIONING CONTROL ASSEMBLY WITH LOWER CENTER INSTRUMENT PANEL FINISH PANEL


  1. Put protective tape around the air conditioning control assembly.


    E281399E01


    Text in Illustration 
    *A
    for Automatic Air Conditioning System
    *B
    for Manual Air Conditioning System
    *1
    Protective Tape
    *2
    Air Conditioning Control Assembly
    *3
    Center Lower Instrument Panel Finish Panel
    -
    -

  1. Using moulding remover B, detach the 8 clips, 2 claws and guide.

  1. Disconnect each connector and remove the air conditioning control assembly together with the center lower instrument panel finish panel.



    E281401E01
  1. Detach the 3 clips and remove the air conditioning control assembly from the center lower instrument panel finish panel.
    Text in Illustration 
    *1
    Air Conditioning Control Assembly
    *2
    Center Lower Instrument Panel Finish Panel



10. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    E281401
  1. Detach the 3 clips and remove the lower center instrument panel finish panel from the air conditioning control assembly.



11. REMOVE POWER OUTLET SOCKET ASSEMBLY


    B355992E01
  1. Using a screwdriver, detach the 2 claws and remove the power outlet socket assembly.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Use the same procedure described for the another side.



12. REMOVE POWER OUTLET SOCKET COVER


    B355993
  1. Detach the 2 claws and remove the power outlet socket cover.

    HINT:
    Use the same procedure described for the another side.