SIDE AIRBAG SENSOR (for CrewMax) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH (for Front Side) |
![]() |
Using a screwdriver, detach the 4 claws and remove the inside handle bezel.
| 4. REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Front Side) |
![]() |
Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel LH.
| *A | for Regular Cab |
| *B | for Double Cab, for CrewMax |
![]() |
Disconnect the master switch connector.
| *A | for Regular Cab |
| *B | for Double Cab, for CrewMax |
| 5. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH (for Front Side) |
![]() |
Detach the 3 clips and remove the door lower frame bracket garnish.
| 6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Front Side) |
![]() |
Remove the 2 screws.
Using a clip remover, remove the clip.
Detach the 9 clips and remove the trim cover. Then disconnect the connector.
![]() |
Disconnect the 2 cables from the inside handle.
Remove the inside handle.
| 7. REMOVE FRONT SIDE AIRBAG SENSOR |
![]() |
Disconnect the connector.
Remove the screw and side airbag sensor.
| 8. REMOVE REAR SEAT ASSEMBLY (for Rear Side) |
Remove the rear seat (Click here).
| 9. REMOVE REAR DOOR SCUFF PLATE LH (for Rear Side) |
![]() |
Detach the 6 claws and 2 clips, and remove the rear door scuff plate LH.
| 10. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Rear Side) |
| 11. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH (for Rear Side) |
![]() |
Detach the 2 claws and remove the cover.
![]() |
Loosen the bolt and disconnect the rear seat outer belt assembly.
![]() |
Detach the 6 clips and remove the lower quarter trim panel assembly LH.
| 12. REMOVE REAR SIDE AIRBAG SENSOR |
![]() |
Remove the bolt and side airbag sensor.
Disconnect the connector.