Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Manual Tilt)

STEERING COLUMN ASSEMBLY (for Manual Tilt) > REASSEMBLY

for Preparation Click here



1. INSTALL STEERING COLUMN BRACKET SPACER


    C104853E02
  1. Fix the steering column in a vise between aluminum plates or a cloth. Then install the steering column bracket spacer to the steering column.
    Text in Illustration 
    *a
    15°

    NOTICE:
    1. Install the steering column bracket spacer so that it is facing in the direction shown in the illustration.
    2. When using a vise, do not overtighten it.



2. INSTALL IGNITION SWITCH ASSEMBLY


    C155157
  1. Attach the 2 claws to install the ignition switch to the steering switch bracket.



3. INSTALL KEY INTERLOCK SOLENOID


    C155158
  1. Install the key interlock solenoid to the steering lock with the 2 screws.



4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY


    C155156
  1. Attach the 2 claws to install the unlock warning switch to the steering switch bracket.



5. INSTALL IGNITION SWITCH LOCK CYLINDER
  1. Check that the ignition switch lock cylinder is in the ACC position.



    C103932E07
  1. Install the ignition switch lock cylinder to the steering lock.
    Text in Illustration 
    *a
    LOCK
    *b
    ACC
    *c
    ON
    *d
    START

  1. Check that the ignition switch lock cylinder is securely installed.



6. INSPECT STEERING LOCK OPERATION


7. INSTALL UPPER STEERING COLUMN CLAMP WITH SWITCH BRACKET ASSEMBLY
  1. Temporarily install the upper steering column with switch bracket and the steering lock bracket with 2 new tapered-head bolts.



    C155159
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



8. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)
  1. Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.



    C155160
  1. Push the transponder key amplifier upward and install it to the upper switch bracket.

    NOTICE:
    Do not push the amplifier up with excessive force.



9. INSTALL KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System)
  1. Align the key cylinder light with the installation position of the switch bracket with the key cylinder light inclined.



    C155160
  1. Push the key cylinder light upward and install it to the switch bracket.

    NOTICE:
    Do not push the key cylinder light up with excessive force.