Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)

STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > REASSEMBLY

for Preparation Click here



1. INSTALL STEERING COLUMN BRACKET SPACER


    C104853E02
  1. Fix the steering column in a vise between aluminum plates or a cloth. Then install the steering column bracket spacer to the steering column.
    Text in Illustration 
    *a
    15°

    NOTICE:
    1. Install the steering column bracket spacer so that it is facing in the direction shown in the illustration.
    2. When using a vise, do not overtighten it.



2. INSTALL IGNITION SWITCH ASSEMBLY


    C155157
  1. Attach the 2 claws to install the ignition switch to the bracket switch.



3. INSTALL KEY INTERLOCK SOLENOID


    C155158
  1. Install the key interlock solenoid to the bracket switch with the 2 screws.



4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY


    C155156
  1. Attach the 2 claws to install the unlock warning switch to the switch bracket.



5. INSTALL IGNITION SWITCH LOCK CYLINDER
  1. Check that the ignition switch lock cylinder is in the ACC position.



    C103932E05
  1. Install the ignition switch lock assembly to the switch bracket.
    Text in Illustration 
    *a
    LOCK
    *b
    ACC
    *c
    ON
    *d
    START

  1. Check that the ignition switch lock cylinder is securely installed.



6. INSPECT STEERING LOCK OPERATION


7. INSTALL UPPER STEERING COLUMN CLAMP WITH SWITCH BRACKET ASSEMBLY
  1. Temporarily install the steering column upper with switch bracket and the steering lock bracket with 2 new tapered-head bolts.



    C159756
  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



8. INSTALL TRANSPONDER KEY AMPLIFIER
  1. Align the transponder key amplifier with the installation position of the switch bracket with the amplifier inclined.



    C155160
  1. Push the transponder key amplifier upward and install it to the switch bracket.

    NOTICE:
    Do not push the amplifier up with excessive force.



9. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU


    C159704
  1. Install the ECU with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the 2 ECU connectors.