Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT RELAY

HEADLIGHT RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT RELAY


E281420
  1. Remove the headlight relay from the engine room relay box.



    E277745E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 5
      Battery voltage not applied to terminals 1 and 2
      10 kΩ or higher
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      If the result is not as specified, replace the headlight relay.

  1. Install the headlight relay to the engine room relay box.