Home › BODY ELECTRICAL › OTHER SYSTEM › CENTER POWER OUTLET SOCKET (for Floor Shift Type)

CENTER POWER OUTLET SOCKET (for Floor Shift Type) > REMOVAL

for Preparation Click here



1. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
  1. Move the shift lever to N.



    B355386E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover B, detach the 6 clips and remove the upper rear console panel sub-assembly.



2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B355388
  1. Detach the 12 clips and remove the upper console panel sub-assembly.



3. REMOVE CONSOLE BOX BEZEL
  1. Disconnect the connector.



    B165430E02
  1. Using a screwdriver, detach the 5 claws and remove the console box bezel.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



4. REMOVE POWER OUTLET SOCKET ASSEMBLY


    B165995E02
  1. Using a screwdriver, detach the claw and remove the power outlet socket assembly.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



5. REMOVE POWER OUTLET SOCKET COVER


    B165431E01
  1. Detach the 2 claws and remove the power outlet socket cover.



6. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY (for Double Cab)


    B355389
  1. Using a moulding remover B, detach the 7 clips and remove the rear console end panel sub-assembly.

  1. w/ Power Outlet Socket:
    Detach the 2 wire harness clamps and disconnect the connector.



7. REMOVE POWER OUTLET SOCKET ASSEMBLY (for Double Cab)


    B165432E02
  1. Using a screwdriver, detach the claw and remove the power outlet socket assembly.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



8. REMOVE POWER OUTLET SOCKET COVER (for Double Cab)


    B165433E01
  1. Detach the 2 claws and remove the power outlet socket cover.