Home › BODY › EXTERIOR › FENDER LINER (for Front Side)

FENDER LINER (for Front Side) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
  1. for Resin Type Bumper:

    1. Install the front wheel opening extension pad LH with the 5 screws.

    2. Install the clip.

  1. for Steel Type Bumper:

    1. Install the front wheel opening extension pad LH with the 3 screws.

    2. Install the clip.

    3. Install the 2 pin hold clips.



2. INSTALL FRONT FENDER LINER LH
  1. Install the front fender liner LH with 13 new grommets.

  1. Install the 4 screws and clip.



3. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
  1. for Resin Type Bumper:

    1. Install the front wheel opening extension pad RH with the 5 screws.

    2. Install the clip.

  1. for Steel Type Bumper:

    1. Install the front wheel opening extension pad RH with the 3 screws.

    2. Install the clip.

    3. Install the 2 pin hold clips.



4. INSTALL FRONT FENDER LINER RH
  1. Install the front fender liner RH with 13 new grommets.

  1. Install the 4 screws and clip.



5. INSTALL FRONT FENDER MUDGUARD LH (w/ Mudguard)
  1. Install the front fender mudguard LH with the 3 screws.

  1. Install the clip.



6. INSTALL FRONT FENDER MUDGUARD RH (w/ Mudguard)

HINT:
Use the same procedure described for the LH side.



7. INSTALL SIDE STEP ASSEMBLY LH (w/ Side Step)


  1. Install the side step with the 8 bolts.

    Torque:
    19.5 N*m{ 199 kgf*cm , 14 ft.*lbf }



    B169240E05



8. INSTALL SIDE STEP ASSEMBLY RH (w/ Side Step)

HINT:
Use the same procedure described for the LH side.