Home › BODY ELECTRICAL › AUDIO / VISUAL › SATELLITE RADIO TUNER (for Floor Shift Type)

SATELLITE RADIO TUNER (for Floor Shift Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B355384
  1. Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.



4. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
  1. Move the shift lever to N.



    B355386E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover B, detach the 6 clips and remove the upper rear console panel sub-assembly.



5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B355388
  1. Detach the 12 clips and remove the upper console panel sub-assembly.



6. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


  1. Put protective tape around the air conditioning control assembly.


    E281399E01


    Text in Illustration 
    *A
    for Automatic Air Conditioning System
    *B
    for Manual Air Conditioning System
    *1
    Protective Tape
    *2
    Air Conditioning Control Assembly
    *3
    Center Lower Instrument Panel Finish Panel
    -
    -

  1. Using moulding remover B, detach the 8 clips, 2 claws and guide.

  1. Disconnect each connector and remove the air conditioning control assembly together with the center lower instrument panel finish panel.



    E281401E01
  1. Detach the 3 clips and remove the air conditioning control assembly from the center lower instrument panel finish panel.
    Text in Illustration 
    *1
    Air Conditioning Control Assembly
    *2
    Center Lower Instrument Panel Finish Panel



7. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY


    B353907
  1. Remove the 4 bolts.



    B353908
  1. Pull the radio and display receiver assembly with bracket to detach the 3 clips and 2 guides on the backside of the radio and display receiver assembly with bracket.

  1. Disconnect each connector and remove the radio and display receiver assembly with bracket.



8. REMOVE NO. 1 NAVIGATION WIRE


    B353898
  1. Disconnect each connector and remove the No. 1 navigation wire.



9. REMOVE NO. 1 RADIO RECEIVER BRACKET


    B353899
  1. Remove the 5 bolts and No. 1 radio receiver bracket.



10. REMOVE NO. 2 RADIO RECEIVER BRACKET


    B353900
  1. Remove the 5 bolts and No. 2 radio receiver bracket.



11. REMOVE STEREO COMPONENT TUNER ASSEMBLY


    B355132
  1. Detach the 2 guides and remove the stereo component tuner assembly as shown in the illustration.