Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Regular Cab)

FRONT DOOR SPEAKER (for Regular Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B165652
  1. Detach the 3 clips and front lower door frame bracket garnish.



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT UPPER ARMREST BASE PANEL LH (w/ Power Window)


    B360300
  1. Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel LH.



    B360302
  1. Disconnect the master switch connector.



4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)


    B084267E03
  1. Insert a clip remover between the plate and trim.

  1. Turn the handle clockwise to remove the handle.



5. REMOVE FRONT DOOR ARMREST COVER LH


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B167314E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 10 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    B356598
  1. Remove the 4 screws.

    NOTICE:
    Do not touch the cone part of the speaker.

  1. Disconnect the connector and remove the front No. 1 speaker assembly.