Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER (for Double Cab)

REAR DOOR SPEAKER (for Double Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR DOOR FRAME GARNISH LH


    B167090
  1. Detach the 4 clips and remove the rear door frame garnish.



2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH


    B166242
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH


    E278381
  1. Using a moulding remover A, detach the 2 clips and 5 claws, and remove the rear upper door armrest base panel LH.



    E278383
  1. Disconnect the connector.



4. REMOVE REAR DOOR ARMREST COVER LH


5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B354853E01
  1. Remove the 2 screws.

  1. Using a clip remover, remove the clip.

  1. Detach the 9 clips and remove the trim cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.



6. REMOVE REAR NO. 1 SPEAKER ASSEMBLY


  1. Remove the 3 screws.


    B356597E01


    Text in Illustration 
    *A
    for Standard
    *B
    for 7 Speakers

    NOTICE:
    Do not touch the cone part of the speaker.

  1. Disconnect the connector and remove the rear No. 1 speaker assembly.