Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA POLE

RADIO ANTENNA POLE > INSTALLATION

for Preparation Click here



1. INSTALL PULL TOP ANTENNA POLE SUB-ASSEMBLY


    B355089
  1. Install the pull top antenna pole sub-assembly and tighten it by hand until it is fully seated.

  1. Using an 8 mm (0.315 in.) wrench or antenna mast tool, tighten the pull top antenna pole sub-assembly clockwise approximately 1/8 turn (20 to 45 degrees).

    HINT:
    1. Do not overtighten the pull top antenna pole sub-assembly. Tighten the pull top antenna pole sub-assembly with your fingers, not your whole hand.
    2. Do not use pliers to tighten the pull top antenna pole sub-assembly as it can leave marks on the pull top antenna pole sub-assembly surface.
    3. The pull top antenna pole sub-assembly cannot be tightened by hand to the proper torque specification.

    Torque:
    3.3 N*m{ 3.4 kgf*cm , 29 in.*lbf }